Color box printing lamination production process

Color box printing lamination production process

The lamination in color box printing is said to be over-plastic “laminating glue” film “and so on, will be transparent plastic film through the hot pressure pasted to the appearance of the printed matter of a process. After the lamination of the color box has more advantages, for example, it can be waterproof, dirt, color and increase the gloss and other advantages, now the color box are used in this production process. Rarely laminating packaging products are cartons, boxes, bags, fertilizer bags, seed bags, stickers and so on.

    Although this process, it sounds relatively simple, but in order to print the most perfect color box packaging, this process also has strict requirements.

1 open the power supply of the machine, hit the air compressor open valve inflatable. Press the alarm, turn on the host, equipment operation.

2 open the electric switch in advance of heating, the temperature will be adjusted at about 100 degrees. According to the thickness of the paper or material to adjust the temperature, generally controlled between 90110 degrees.

3 the product to be laminated centered on the upper to the table, adjust the two sides of the block gauge to the appropriate position.

4 Adjust the flyer and suction nozzle, adjust the pressure of the two pressure wheels at the paper feed end, the pressure should be consistent, to prevent the paper from going sideways.

Color box printing lamination

5 according to the width of the paper, adjust the size of the edge, the edge is generally about 1CM.

6 Adjust the cutter disk of the paper cutter, the paper receiving conveyor belt and the paper receiving table of the blocking gauge, the blocking plate is about 1CM away from the paper.

7 will be the film in the direction of the paper through the guide roller, wrinkle roller, adjusting roller into the press part. And adjust the film position and the position of the conveyed paper adhere to the neat.

8 According to the thickness of the paper to adjust the pressure of the composite steel rod, generally controlled between 10 Pa – 15 Pa.

9 equipment adjustments, with defective products according to the sample and manufacturing orders for the test machine after signing the sample production.

Share this post

Leave a Reply

Your email address will not be published. Required fields are marked *